The high temperature and humid environment in summer can easily affect Metal Baler. To do a good job of maintenance, you need to pay attention to the following key points: Hydraulic system maintenance:
The temperature is high in summer, and the viscosity of the hydraulic oil will decrease, which can easily lead to unstable system pressure. It is necessary to check the temperature and quality of the hydraulic oil regularly. When the oil temperature exceeds 60℃, cooling measures should be taken in time, such as checking whether the radiator is blocked, cleaning the dust and debris on the surface of the radiator, and ensuring the heat dissipation effect; if the oil temperature continues to be too high, a cooling device can be added. At the same time, shorten the replacement cycle of the hydraulic oil to prevent the oil from oxidizing and deteriorating. It is also necessary to check the sealing of each component of the hydraulic system, and replace aging and damaged seals in time to avoid affecting the operation of the equipment due to oil leakage.
Electrical system maintenance: The air humidity is high in summer, and electrical components are easily affected by moisture. Regularly check the electrical circuit of the Metal Baler to check whether there are any problems such as damage, aging, short circuit, etc., and wrap the exposed wires to prevent leakage. Check the dust in the electrical control cabinet, use dry compressed air to blow, and keep the control cabinet dry and clean. In addition, the operating temperature of the motor should be checked. If the temperature is too high, check whether the cooling fan of the motor is running normally and whether the ventilation around the motor is good. Maintenance of mechanical parts: High temperature will accelerate the wear of mechanical parts, and the lubrication of various transmission parts needs to be strengthened. Check the lubrication of gears, chains, bearings and other parts, and replenish or replace grease in time. At the same time, since the metal parts expand and contract significantly when the equipment is running in summer, it is necessary to regularly check whether the connecting bolts of each component are loose. If they are loose, tighten them in time to prevent equipment failure caused by loose parts. In addition, pay attention to check whether the surface of the piston rod of the hydraulic cylinder is scratched or rusted to avoid affecting the sealing performance and service life of the hydraulic cylinder.
Cleaning and rust prevention: Metal Baler is easily contaminated with dust, debris and oil in summer. It is necessary to clean the surface and internal debris of the equipment in time to keep the equipment clean and tidy to prevent debris from entering the interior of the equipment and causing component wear. For metal parts that are exposed to the air for a long time, such as the fuselage and frame, anti-rust paint or anti-rust oil can be applied to prevent rust and corrosion. At the same time, pay attention to the drainage of the equipment working environment to avoid stagnant water soaking the equipment, further aggravating rust.
