english 
1. Daily cleaning
After each use, metal debris and dust on the equipment should be cleaned in time. You can use a compressed air gun to blow away the debris in the cutting area, work surface and equipment gaps to prevent the accumulation of debris from affecting the operation of the equipment or causing component wear. For some oil and stains adhering to the surface of the equipment, you can wipe them with a clean rag dipped in an appropriate amount of neutral detergent, then wipe them clean with clean water and dry them. Avoid using highly corrosive detergents to avoid damaging the surface of the equipment.
2. Tool maintenance
The tool is a key component of Metal Shear and requires special attention to maintenance. Check the wear of the tool regularly. If the tool edge is found to be blunt or notched, it should be sharpened or replaced in time. When sharpening the tool, choose the appropriate sharpening equipment and method according to the material and specifications of the tool to ensure that the sharpened tool meets the cutting requirements. At the same time, keep the tool clean, wipe it clean after each use, and apply an appropriate amount of anti-rust oil to prevent the tool from rusting.
3. Transmission parts maintenance
Metal Shear's transmission parts such as gears, chains, guide rails, etc. need to be lubricated regularly. According to the frequency of use of the equipment and the working environment, apply an appropriate amount of lubricating oil or grease to the transmission parts at regular intervals to reduce friction, reduce wear, and ensure smooth transmission. At the same time, check the tension of the chain. If there is any looseness, adjust it in time to ensure the stability of the chain transmission.
4. Electrical system inspection
Regularly check the connection of the electrical system to ensure that the wire joints are firm and there is no looseness, damage or short circuit. Check whether the control buttons and switches function normally. If there is a fault, repair or replace it in time. In addition, keep the electrical control cabinet clean to prevent dust and moisture from entering, which will affect the performance and life of electrical components.
5. Regular comprehensive inspection
Every once in a while, conduct a comprehensive inspection and maintenance of the Metal Shear. In addition to the above inspections, the overall structure of the equipment should be checked for looseness, deformation or damage, and any problems found should be repaired and handled in a timely manner. At the same time, the performance of the equipment should be tested and calibrated to ensure that the equipment is in the best working condition.
