Metal Chip Combination Machine Cleaning Guide

Proper cleaning is essential to maintain performance and prevent component damage. Follow this systematic, safety-focused approach.

1 Power Down and Disconnect

Always start by shutting down the machine and disconnecting its power source. This eliminates the risk of accidental startup during cleaning, ensuring operator safety and avoiding damage to moving parts.
2 Remove Residual Metal Chips

Focus on removing residual metal chips from the machine's key areas. Begin with the feed inlet and hopper, using a soft-bristled brush or a plastic scraper to gently dislodge accumulated chips.
Avoid sharp tools that could scratch or dent the surfaces, as this might lead to future chip buildup or equipment malfunctions. For hard-to-reach spots inside the processing chamber, use compressed air (at a moderate pressure) to blow out loose chips, ensuring no debris remains that could interfere with crushing, compressing, or separating functions.
3 Clean Separation Components and Conveyor Systems

Wipe these parts with a clean, dry cloth to remove oil, coolant, or fine chip dust that may have adhered to surfaces. If there are signs of oil or coolant residue, use a mild, non-corrosive cleaning solution compatible with the machine's material.
Avoid harsh chemicals that could degrade rubber seals or metal coatings. After wiping with the solution, follow up with a dry cloth to remove any moisture, as leftover dampness can cause rust or corrosion over time.
4 Post-Cleaning Check

Inspect all moving parts (such as gears and bearings) to ensure no chips or debris are trapped, and verify that seals and gaskets are clean and intact.
Once cleaning is complete, reconnect the power only after confirming all components are dry and free of obstructions. Regular, thorough cleaning following these steps helps keep the machine running smoothly and extends its service life.